4. Enter the Network Key in the tablet to connect to the network.
5. Open the GoFree application - the unit should be automatically detected. The name
displayed will be either the default, or that assigned in the Device Name setting. If the unit
does not appear, follow the on screen instructions to manually find the device.
6. Select the graphic icon of the unit. The unit displays a prompt similar to the following:
7. Select Yes for one-time connection, or Always if device is to be remembered for regular
connection. This setting can be changed later if required.
Ú
Note: The internal wireless module only supports GoFree connection to itself. Other
units connected on the network are not visible.
Connecting a smartphone
Install the GoFree App on the smartphone before following this procedure.
1. Set the internal wireless to Access Point mode. To do this, select the Wireless devices
page in the Wireless settings dialog and then select the unit's Internal Wireless. Next,
select the Mode option and then select Internal Access Point.
2. Select a device on the Wireless devices page to view its Network Key.
3. Navigate to the wireless network connection page on the smartphone, and find the unit
or GoFree wireless xxxx network. If more than one is in range, review the Wireless devices
page from the unit's Wireless settings dialog to confirm which wireless device is
connected to the unit.
4. Enter the Network Key in the smartphone to connect to the network.
5. Open the GoFree application on the smartphone, the unit should be automatically
detected. The name displayed will be either the default, or that assigned in the Device
Name setting. If the unit does not appear, follow the on screen instructions to manually
find the device.
The MFD's display is shown on the smartphone. To change the MFD's display on the
smartphone, use the MFD to change the display on the MFD. The display change on the
MFD is reflected on the smartphone.
Uploading log files to C-MAP Genesis
To upload a recorded Echosounder log file to C-MAP Genesis, select the file you want to
upload from the Files panel and select the upload to C-MAP Genesis option.
Ú
Note: You must be connected to a wireless hotspot to upload recorded log files to C-
MAP Genesis.
Ú
Note: Recorded log files can also be uploaded to C-MAP Genesis if you have specified
Upload to C-MAP Genesis in the Record Echo dialog. For more information, refer to
"Start Recording log data" on page 86.
Wireless settings
Provides configuration and setup options for the wireless functionality.
For more information, refer to the NSO evo3 Installation Manual.
Wireless connection | NSO evo3 Operator Manual
103
To Next Page
Loading...
Need help?
General
