Selecting the work profile
The AP70/AP80 can be set up with 6 different work profiles associated with different work
modes or preferences. Use the AP70/AP80 controller to set up the different work profiles. In
the MFD, the active work profile is displayed in the MFD Autopilot controller. If the MFD has
control of the autopilot, you can use it to specify the active work profile.
To change the work profile using the MFD, the autopilot must be in standby mode.
1. Open the Autopilot controller and set the autopilot in standby mode
2. Select the Work profiles button to display defined work profiles in the Work profiles
selection page
3. Select the work profile you want to activate
Enabling and disabling thrusters
Select the Thruster button to disable the thruster.
Select the Disabled thruster button to activate the thruster.
Autopilot settings
The autopilot settings can be split between settings done by the user, and settings done
during installation and commissioning of the autopilot system.
• User settings can be changed for various operational conditions or user preferences
• Installation settings are defined during commissioning of the autopilot system. No
changes should later be done to these settings
Both user settings and installation settings depends on which autopilot computer that is
connected to the system.
The following sections describe the settings that can be changed by the user. The settings
are described per autopilot computer.
Autopilot | NSO evo3 Operator Manual
65
To Next Page
Loading...
