Audio
If a compatible NMEA 2000 or Ethernet audio system is connected to the network, you can
use the unit to control and customize the audio system on your vessel.
Before you can start using your audio equipment, it must be installed according to the unit's
Installation manual and to the documentation included with the audio device.
Enabling audio
A compatible audio device connected to the NMEA 2000 network should automatically be
identified by the system. If not, enable the feature from the Advanced Settings dialog.
Audio server
If multiple audio sources are connected to the same network, one of the devices must be
selected as the Audio server. If only one of the devices is present, it is the selected Audio
server by default.
Operating the audio system
1. Select Audio in the Control bar to open the Audio controller
2. Select the Audio source button and then select the audio source
-
Number of sources depends on the active audio server
3. Use the controller buttons to control your audio system
For an overview of audio control buttons and tools, refer to "Audio control buttons" on page 112.
Also see "Audio Tools" on page 112.
For available options, refer to the documentation following your audio equipment.
The Audio controller
The control buttons, tools and options vary from one audio source to another.
1 Audio controller
2 Audio source
17
Audio| NSO evo3 Operator Manual
111
To Next Page
Loading...
