Language
Controls the language used on this unit for panels, menus, and dialogs. Changing the
language causes the unit to restart.
Key beeps
Controls the loudness of the beep sound when a key is pressed.
Default setting: Loud
Time
Controls the local time zone offset, and the format of the time and date.
Restore defaults
Allows you to select which settings are to be restored to their original factory settings.
Power Control
¼
Note: This option is available for R2009 Control units only.
Used for defining the R2009 Control unit as a power slave.
This setting is only applicable if the yellow wire is connected to ignition or to a stand-alone
switch that applies 12 V/24 V.
¼
Note: You cannot use the STANDBY/BRILLIANCE key to power down a unit that is set
to power slave. The unit is powered off when the power master is powered down, or
when the system power is removed.
Files
File management system, used to browse the contents of the unit's internal memory and
inserted SD card.
Advanced
Shows a panel with more advanced settings. Used for setting how your system displays
various user interface information. In addition, controls which features are shown in the
interface.
About
Displays copyright information, software version, and technical information for this unit.
Network settings
The unit has Ethernet, NMEA 0183 and NMEA 2000 port connections on the back allowing
you to connect the unit to your network. Use the Network settings dialog to setup networks
and connect to network devices.
48
Software setup | R2009/R3016 User manual
To Next Page
Loading...
Need help?
General
