Singer 5050 - Choosing and Changing Needles; Changing Lhe Needle Plale; Changing Screw-On Presser Feel

Choosing and changing
needles
• Raiseneedleto itshighest position.
•
loosen needle clamp screw and remove
needle.
• With flat side ot needle to the
back, insert
new needleup into
clamp asfar as itwillgo.
•
T1ghten needle clamp screwsecurely.
Changing the needle
plate (A), (C)
• Raiseneedle and pressertoot,
•
Open slide plote.
•
lift up needle plote from right comer and
slide out from underfoot.
• To
replace needle plote, slide it under pin (1)
and push it firmlyto the left..
•
Press down until it snapsinto place.
Changing screw-en
presser feet (H)
• Raiseneedle and presserfoot.
• loosen presser foot screw (1)
and remove
presser toot with shank (2), guiding it toward
vou
ond to the righ1.
• To replace presser foot with shank, hook
shank around the presser bar
and tighten -.
presserfoot screw withthe useot a coin.
12