Starting
a
seam
Place fabric under presser foot 1/2 inch
(12mm) from rear of fabricoAlign the right
edge
with
one
of the seam guidelines on the needle
plate. Lowerthe presserfoot.
Backstitch to the
edge
of the fabric for
reinforcement by pushing in the reversebutfon
located
in center of the stitch length olol, Hold
butfon inuntil stitching reaches
edge
of fabrico
Release push butfon for forward stitching.
Guidingand
supporting
fabric
• For tricot,
and
other similar synthetic
knits,
apply
gentletension by holding the fabric at
the front
and
back
of presserfoot asvou sew.
Do not pull fabrico
• Forelasticated fabric, stretch lace,
and
knits
with an unusual amount of elasticity, hold the
fabric firmily in front
and
back
of the presser
foot to stretch the seam as the stitches are
being
placed.
30
To Next Page
Loading...
