IMPORTANT SAFETV INSTRUCTIONS
When using this
machine,
basic
safety
precautions
should always
be
followed
including
the
following:
Read
ali
instructions before using this
machine.
DANGER -
lo
reduce
the
rtsk of
electric
shock:
•
lhe
machine
should never
be
left
unattended
when
plugged
in. Always
unplug
the
machine
from
the
electric
outlet
immediately
after using
and
before
cleaning.
• Always
unplug
before
relamping.
Replace
bulb
with the same
type
rated 15 watts.
Besureto
replace
the
face
plate
which covers the light
bulb
before
operating
the machine.
WARN
I
NG
-
lo
reduce
the
rlsk of burns, fire,
electric
shock
or injury to persons:
• Be sure
that
the
electrical
voltage
of
the
socket outlet (wall receptacle) is the same as
the
rated
voltage
of
the
motor.
• Use this
machine
only
for its
intended
use as
described
in this Operator's Guide.
Use
only
attachments
recommended
by
the
manufacturer as
contained
in the
Operator's Guide.
•
lo
disconnect,
turn
ali
controls to the off ("O") position, then remove
plug
from outlet.
• Disconnect
the
power-Iine
plug
from
the
socket outlet or switch the
machine
off when
making
any
adjustments in
the
needle
area, such as
threading
needle,
changing
needle,
changing
needle
plate
or
changing
presser foot, etc.
• Always
unplug
the
machine
from
the
electrical
outletwhen
removing covers, lubricating,
or when
making
any
other user servicing adjustments
mentioned
in the Operator's Guide.
• Do
not
attempt
to
adjust
the
motor belt.
Contact
your nearest Service Center should
any
adjustment
be
required.
• Do not
unplug
by
pulling
on cord,
lo
unplug,
grasp
the
plug,
not
the
cord.
•
Handle
the
foot controller with
care
and
avoid
dropping
it on the floor. Be sure not to
place
anything
on
top
of it.
• Always use
the
proper
needle
plate.
lhe
wrong
plate
can
cause the
needle
to break.
• Do not use
bent
needles.
• When sewing,
keep
fingers
away
from
ali
moving
parts.
Special
care
is required
around
the
sewing
machine
needle.
• Do
not
pull
or push
fabric
while
stitching. It
may
deflect
the
needle
causing
it to break.
• Before removing
the
bobbin
case, remove
plug
from
the
socket outlet.
• For
double
insulated machines, when servicing use
only
identical
replacement
parts.
• Never
operate
the
machine
if it has a
damaged
cord
or plug, if it is
not
working properly,
if it hos
been
dropped
or
damaged,
or
dropped
into
the
water. Return the
machine
to
the
nearest outhorized
dealer
or Service Center for examination, repair, electrical, or
mechanical
adjustment.
• Never
operate
the
machine
with
any
air
openings
blocked.
Keep ventilation
openings
of the
machine
and
foot controllerfree from the
accumulation
of lint, dust,
and
loose cloth.
• Never
drop
or insert
any
object
ínto
any
opening.
• Do
not
use outdoors.
2
To Next Page
Loading...
