Sirona C4+ - Mode: MAINTENANCE; Mode: SERVICE ONLY START - STOP; Mode: FC CONTROL MODE ON;OFF - VARIABLE; Mode: TIME - HOURS: MIN

11 Basic treatment center settings in the Mode dialog Sirona Dental Systems GmbH
11.3 Mode: MAINTENANCE Operating Instructions C4
+
59 06 313 D 3382
58 D 3382.201.01.13.02
11.3 Mode: MAINTENANCE
Display of next maintenance date
This dialog displays the number of days until the next
maintenance date. You should have maintenance perfor-
med by your service engineer at least once annually.
The instrument running time is indicated in the lower
right-hand corner of the display (for service engineers
only).
As soon as the time remaining until the next mainte-
nance date is less than 30 days, the message is auto-
matically displayed each time the unit is switched on.
The display message then disappears as soon as an
instrument is removed from its holder.
11.4 Mode: SERVICE ONLY START − STOP
For service engineers only!
11.5 Mode: FC CONTROL MODE ON/OFF − VARIABLE
Direct starter or speed controller foot switch
Presetting of the foot switch control mode for the instru-
ment start.
With direct starter (ON/OFF) presetting, the bar dis-
play always jumps immediately to the maximum value
when you step on the foot switch. You are working with
the displayed maximum value.
With speed controller foot switch (VARIABLE) pre-
setting, the bar display depends on the pedal position.
You are working in a range between 0 and the displayed
maximum value.
This setting can be chosen individually for user A or
B!
11.6 Mode: TIME − HOURS : MIN
Setting the time
Here you can set the time of day in hours and min-
utes.
The hours display flashes first and can be adjusted with
the
– / + keys.
A
MAINTENANCE
360 8
MAINTENANCE
360 8
A
SERVICE ONLY
START – STOP
SERVICE ONLY
START – STOP
A
FC CONTROL MODE
ON/OFF – VARIABLE
FC CONTROL MODE
ON/OFF – VARIABLE
A
TIME – HOURS : MIN
11 : 21
TIME – HOURS : MIN
11 : 21