SKF Matrix Series - 7.6.1 Shut down MAX1 and MAX3

7.6.1 Shut down MAX1 and MAX3
1 Pull the power line plug of the control unit out of the power outlet.
2 Pull the low-voltage plug (Jack plug or DIN-8 plug) of the cable of
the device out of the connecting socket of control unit († Refer to
paragraph below).
Pull jack plug out of control unit
Proceed as follows to pull jack plug out of the connection outlet of
the control unit:
• Special tools required:
– Special tool from the manufacturer (part no. 0125322)
1 Insert special tool (1) in the groove (2) of the jack plug.
2 Turn special key (1) counter-clockwise until the bayonet joint of
the jack plug is unlocked.
1
2
Fig. 53
3 Pull jack plug (1) out of the connection outlet (2) of the control
unit (arrow).
2
1
Fig. 54
68