13
3.10.4 Orientation for external technicians
Prior to commencing any activities, external technicians must be informed by the end user at the place of op-
eration. on site safety provisions, applicable accident prevention procedures and the functions, guards and
protective devices of the device to be connected to the lubrication system.
3.10.5 Provision of personal protective equipment
The end user must provide personal protective equipment suitable for the respective location of operation and
the intended use.
3.11 Operation
The following must be observed during commissioning and operation:
" any and all information within this manual and the in any referenced documents, and
" all laws and regulations that the end-user must observe.
3.11.1 Emergency stopping of the flowmeter unit
In case of an emergency, stop the flowmeter unit as follows:
" Switch off the piece of equipment that uses the flowmeter unit or the piece of equipment to which the
flowmeter unit has been connected.
3.11.2 Transport, installation, maintenance, malfunctions, repairs, shutdown for
maintenance and disposal
" All relevant persons must be informed of the activity prior to starting any work. Observe safe operating
measures and work instructions.
" Use suitable equipment, working methods and tools when lifting and transporting the product.
" Maintenance and repair work can be subject to restrictions due to low or high temperatures (e.g.
changed flow properties of the lubricant). Whenever possible, carry out maintenance and repair work
at room temperature.
" Before conducting any work, depressurise the product or machine to which the product has been con-
nected and secure it against unauthorised activation.
" Ensure through suitable measures that movable or detached parts are immobilised during the work
and that no limbs can get caught in between if there are any inadvertent movements.
" Assemble the product only outside of the operating range of moving parts, at an adequate distance
from sources of heat or cold. Be careful not to damage other units in the machine or impair their func-
tion during installation.
" Dry or cover wet, slippery surfaces accordingly.
" Cover any hot or cold surfaces.
" Work on electrical components must be carried out by electrical specialists only. Carry out work on
electrical components using voltage insulated tools only.
" Make electrical connections only according to the information in the valid wiring diagram, taking into
account relevant regulations of the country of operation and the properties of the local electrical net-
work.
" Do not touch cables or electrical components with wet or damp hands.
" Do not bypass any fuses. Replace any blown fuses with fuses of the same type and rating only.
" Do not drill holes into critical, load-bearing parts. Use existing boreholes whenever possible. Be care-
ful not to damage lines and cables when drilling.
" Observe possible abrasion points. Protect the parts accordingly.
To Next Page
Loading...
Need help?
General
