14
" All components used must be suitable for use at:
– the system’s maximum operating pressure, and
– the maximum and minimum operating temperatures of the product.
" No parts of the lubrication system may be subjected to torsion, shear or bending.
" Before using any parts, check them for contamination, clean if necessary.
" Observe the specified tightening torques. Use a calibrated torque wrench.
" When working with heavy parts, use suitable lifting tools.
" Avoid mixing up or wrong assembly order of dismantled parts. Mark these parts accordingly.
3.12 Commissioning and daily start-up
Ensure the following:
" All safety devices are complete and work properly
" All connections have been correctly made
" All parts have been correctly installed
" All warning labels on the machine are complete, highly visible and undamaged.
" replace illegible or missing warning labels without delay.
3.13 Cleaning
" There is a risk of fire and explosion when using flammable cleaning agents. Only use non-flammable
cleaning agents suitable for the purpose.
" Do not use any aggressive or corrosive cleaning agents.
" Do not use a steam jet or a high pressure cleaner to clean the device. Electrical components may be
damaged. Observe the IP protection class.
" Cleaning work on energised components may be carried out by electricians only.
" Mark damp areas accordingly.
To Next Page
Loading...
Need help?
General
