Section 07 REAR SUSPENSION
Subsection 04 (SKANDIC WT SUSPENSION)
07-04-4
Examine each shock for leaks. Extend and com-
press the piston several times over its entire
stroke then check that it moves smoothly and
with uniform resistance.
Pay attention to the following conditions that will
denote a faulty shock:
– A skip or a hang back when reversing stroke at
mid travel.
– Seizing or binding condition except at extreme
ends of stroke.
– Oil leakage.
– A gurgling noise, after completing one full com-
pression and extension stroke.
Renew if any fault is present.
INSTALLATION
Use a tie-down between front arm and spring axle
to ease installation of front arm screws.
-
CAUTION
Do not clamp directly on shock body.
A22F1FA
To Next Page
Loading...
