Section 07 REAR SUSPENSION
Subsection 05 (DRIVE AXLE)
07-05-4
ASSEMBLY
8,9,13, Drive Axle and Sprocket
To assemble press fit sprockets, use a press and
a suitable pipe as illustrated. Sprockets must be
assembled according to the following dimen-
sions.
1. Pipe
S-Series
A. 65.8 mm (2-19/32 in)
B. 159.3 mm (6-17/64 in)
C. 282.3 mm (11-7/64 in)
D. 375.8 mm (14-51/64 in)
Skandic WT/SWT/WT LC
1. Gearbox side
A. 93.5 mm (3-43/64 in)
B. 157 mm (6-11/64 in)
C. 399 mm (15-45/64 in)
D. 462.5 mm (18-13/64 in)
All Models
Ensure to align indexing marks of each sprocket
when assembling.
TYPICAL
1. Indexing marks aligned
The maximum desynchronization for the sprock-
ets is 1.5 mm (1/16 in).
To check this tolerance, place axle assembly on a
plane surface and measure the gap between
sprocket tooth and surface.
A00F07A
1
A06D1XA
A
BB
C
D
A22D18A
B
C
D
1
A
A24D05A
1
To Next Page