IV
WHAT’S NEW 0
INTRODUCTION
• List of abbreviations used in this manual.
SERVICE TOOLS AND SERVICE PRODUCTS 01
• Complete new section.
LEAK TEST AND ENGINE DIMENSION MEASUREMENT 04-04
• Procedure for cylinder/piston clearance measurement.
• Procedure for combustion chamber volume measurement.
• Cylinder head warpage specifications.
CARBURETOR AND FUEL PUMP 04-11
• New procedure for choke plunger adjustment. This procedure is the same as in the
Service Bulletin
96-30.
CHAINCASE 05-07
• Countershaft bearing sealed side is facing cover.
GEARBOX 05-08
S-Series
• Countershaft bearing sealed side is facing cover.
Skandic WT Series
• New procedure.
TESTING PROCEDURE 06-06
• Complete new testing procedures using only a multimeter.
FORMULA Z 670 SUSPENSION 07-03
• Complete new procedure.
DRIVE AXLE 07-05
Skandic WT/SWT/WT LC
• New removal procedure. There is no more need to remove gearbox.
WHAT’S NEW
To Next Page
Loading...
