Skope ReFlex Underbench - Cartridge End Panel; Refrigeration System; Before Servicing

28
Replacement Procedures
Service Manual
SKOPE Reflex Underbench Fridge and Freezer
Cartridge End Panel
The panel at the left hand end of the cabinet can be replaced.
Refrigeration System
Before
Servicing
Overview
Ensure you have read and understood this manual before starting any servicing.
Important
• SKOPE hydrocarbon refrigeration systems must only be serviced by appropriately skilled
and qualified refrigeration mechanics.
• Servicing a sealed refrigeration system must occur at a hydrocarbon workshop or service
area with dedicated hydrocarbon equipment and personal protective equipment (PPE).
• All local hydrocarbon storage and handling regulations and procedures must be followed at
all times.
Ensure all electronic controller alarms diagnostics and refrigeration system diagnostics are
performed to confirm a refrigeration system fault is present.
Check all components including the electronic controller and electrical systems.
Ensure your work area is well ventilated.
Safety hazards
The main hydrocarbon safety hazards are:
• Flammability
• Venting of hydrocarbon and compressor oil
• Asphyxiation
Refrigerant identification
Correctly identifying the refrigerant is critical to maintain safety and the correct functioning of
the cabinet.
Procedure 13: To replace the end panel
1. Unplug the cabinet from the power supply.
2. Unscrew and remove the front panel:
• two screws at the bottom
• two screws at the top.
3. Unscrew and remove the end panel:
• two screws at the back of the cabinet
• four screws at the side of the cabinet
4. Fit the replacement end panel, and refit the front panel.
IMPORTANT
Use only dedicated hydrocarbon SKOPE OEM spare parts.
DO NOT use alternative parts.
For safety compliance, use only SKOPE-supplied components
specified for the appliance.