57
SKOPE Reflex Underbench Fridge and Freezer
Maintenance
Service Manual
8 Maintenance
Drawers
Where fitted, drawers should be removed for cleaning. Pull the drawer out of the cabinet,
release latches at side of drawer as shown, and lift the drawer out at an angle. The drawer
slider can also be removed by releasing the side catches as shown. Reverse operation to refit
drawers to cabinet after cleaning. (see “Drawers” on page 9).
Cabinet
Ensure the cabinet is unplugged from the power supply before cleaning.
Wipe the outside of the cabinet with a damp cloth, and the inside of the cabinet with standard
stainless steel cleaners suitable for food preparation areas. Take care to keep moisture away
from electrical parts.
Condenser Coil
The condenser coil must be kept clean. SKOPE strongly recommends monthly cleaning of the
condenser coil and air filter. Do NOT use hard or sharp tools to clean the coil as these may
cause damage.
IMPORTANT
Do NOT use abrasive, corrosive or solvent based cleaners, as
this could damage the protective coating on the cabinet
exterior.
WARNING
Unplug the cabinet from the power supply before cleaning the
condenser coil.
Procedure 30: To clean the condenser coil and condenser filter
1. Unplug the cabinet from the power supply.
2. The filter is located behind the cartridge
bottom grille. Rotate the grille out and slide the
filter up and off the cabinet.
3. Clean the filter with a vacuum cleaner, wash
with cold water and shake off any excess
water before refitting. Do NOT apply hot water,
blow-dry or place in dishwasher. If necessary,
discard and refit new filter.
4. With the cabinet unplugged from the power
supply and the filter removed (see steps
above), brush the condenser coil with a soft
brush to remove any dust and fluff.
5. Refit the filter, close the bottom grille and
reconnect to the power supply.
Filter
Cartridge
bottom
grille
Coil
To Next Page
Loading...
