EasyManua.ls Logo

SMART Board Interactive whiteboard - Important Information; Precautions and Safety Guidelines

Default Icon
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preface i
Important Information
Please read this manual carefully before setting up and using the SMART Board interactive
whiteboard. With proper care, your interactive whiteboard should provide years of trouble-free
service.
WARNING
If you use a projector with your SMART Board interactive whiteboard, do not
stare into the beam of light created by the projector. Instruct children not to look
in the direction of, or stare at, the beam of light created by the projector.
WARNING
To reduce the risk of fire or electric shock, do not expose this product to rain or
moisture.
NOTE: The information provided in this section applies to the SMART Board
interactive whiteboard (500 series). If you have a Rear Projection SMART Board
interactive whiteboard, a Sympodium
lectern, or a SMART Board for Plasma
Displays
interactive overlay, refer to the guides that came with your model for
warnings, precautions, maintenance and cleaning instructions.
Other Precautions
For operating safety and to avoid damage to the unit, carefully read and observe the following
instructions.
Use care if you decide to move a SMART Board interactive whiteboard that is
mounted on a Floor Stand. Quick stops, excessive force and uneven surfaces may
cause the interactive whiteboard to overturn.
If you are transporting the interactive whiteboard over a distance, we strongly urge
you to completely repackage it using the original packaging. If the original packaging
is no longer available, pack all components with as much padding as reasonably
possible to ensure that they are not exposed to excessive vibration or shock.
Avoid setting up and using the interactive whiteboard in an area with excessive levels
of dust, humidity and cigarette smoke
Avoid leaving cables on the floor. If you must run a cable over the floor, lay the cable
in a flat, straight line and secure it to the floor with tape or a cable management strip
in a contrasting color. Handle cables carefully and avoid excessive bending.
If you require replacement parts, make sure the service technician uses the
replacement parts specified by SMART Technologies Inc. or parts with the same
characteristics as the original

Table of Contents

Other manuals for SMART Board Interactive whiteboard