SMART 330 - Connecting Your Document Camera to an External Display; Connecting to a Projector or Flat-Panel Display; Switching between VGA DVI-D and Composite Output; Connecting to a Digital Projector or HD Display with DVI-D

Connecting your document camera to an external
display
You can connect your document camera directly to an external display to enable the following
functions:
l Use Camera view to view the camera image in full-screen on the external display.
l Use SD Card view to view a full-screen slide show on the external display.
l Access the Camera view’s or SD Card view’s on-screen display menu.
Connecting to a projector or flat-panel display
You can connect your document camera to a projector or a display with the VGA cable.
C  C A U T I O N
Ensure your projector or display is not connected to a power outlet when connecting it to your
document camera.
g To connect to a projector or display
1. Connect the VGA cable to the VGA Out connector on the back of your document camera.
2. Connect the other end of the VGA cable to the VGA In connector on your projector or display.
Switching between VGA DVI-D and Composite output
If you’re using a projector or computer display with a VGA or DVI-D cable, switch your document
camera to VGA DVI-D mode. If you’re using a television with the Composite video cable, switch your
document camera to Composite mode.
g To switch to VGA DVI-D mode
Switch the VGA DVI-D/Composite switch on the side panel to VGA DVI-D.
g To switch to composite mode
Switch the VGA DVI-D/Composite switch on the side panel to Composite.
Connecting to a digital projector or HD display with DVI-D
You can connect your document camera to a digital projector or high-definition display using a DVI-D
single link cable.
C H A P T E R 2
Setting up your SMARTDocumentCamera
13