SMART 330 - Connecting to a Television; Switching between NTSC and PAL

C  C A U T I O N
Ensure your digital projector or display is not connected to a power outlet when connecting it to your
document camera.
N  N O T E S
l Don’t use a DVI-I or DVI-A cable.
l You can use a DVI-D dual link cable, but it will function as a single link DVI-D.
l If you connect your document camera directly to a projector or high-definition display with a
DVI-D cable, you display only the camera image, and not your computer desktop or SMART
Notebook presentation.
g To connect to a digital projector or display
1. Connect a DVI cable from the DVI-DOut connector on your document camera to the DVI-DIn
connector of your digital projector or high-definition display.
2. Switch to VGA DVI-D mode (see page 13).
Connecting to a television
You can connect your document camera to a television with a Composite video cable.
C  C A U T I O N
Ensure your television is not connected to a power outlet when connecting it to your document
camera.
g To connect to a television
1. Connect a Composite video cable from the Composite Out connector on your document
camera to the Video In connector on your television.
2. Switch to Composite mode. See Switching between VGA DVI-D and Composite output on the
previous page.
Switching between NTSC and PAL
When you connect your document camera to a television, switch it to your television’s encoding
system (either NTSC or PAL).
C H A P T E R 2
Setting up your SMARTDocumentCamera
14