Important information
W W A R N I N G
l Failure to follow the installation instructions shipped with your SMART product could result in
personal injury and damage to the product.
l Ensure that any cables extending across the floor to your SMART product are properly
bundled and marked to avoid a trip hazard.
l Do not push foreign objects into the openings on your SMART product.
l Do not open or disassemble the SMART product. You risk electrical shock from the high
voltage inside the casing. Opening the casing also voids your warranty.
l The camera arm on your SMART product has joints that present a pinch hazard when you
move the camera arm. Keep clear of the pinch points.
l Do not stare into the lamp or shine the lamp directly into someone’s eyes. Turn off the lamp
when displaying or capturing images of people.
l Do not overload power outlets or extension cords as this can result in a fire or electric shock.
l Turn off and disconnect your SMART product before a thunderstorm. During a thunderstorm,
do not touch your SMART product or the power plug, because there is a risk of electrical
shock.
l To reduce the risk of fire or electric shock, do not expose the SMART product to rain or
moisture.
C C A U T I O N
l Place your SMART product on a solid surface to prevent it from falling.
l If you have a security cable attached to your SMART product, do not carry or swing your
SMART product by the security cable.
l Do not connect non-shielded interface cables to your SMART product and do not leave
cables connected to unused connectors, because this can cause interference levels that
exceed FCC regulations.
l Avoid setting up and using the SMART product in an area with excessive levels of dust,
humidity and smoke.
i
To Next Page
Loading...
