SMART 330 - Disguising 3 D Models before Presenting Them

5. If you’ve purchased a second cube from SMART and there is more than one 3D model on the
page, manipulate another 3D model by completing steps 3 and 4 with the other cube.
6. When you’re done, move the cube (or cubes) away from the camera.
SMARTNotebook software exits Mixed Reality mode after a few seconds.
Disguising 3D models before presenting them
If you want to hide 3D models in your .notebook file before presenting them to students using Mixed
Reality Tools, you can hide the 3D models with a magic hat.
When you use Mixed Reality Tools, the magic hat disappears after a few seconds, revealing the 3D
model behind it.
N  N O T E
If you cover multiple 3D models on the same page with magic hats, each magic hat has a different
colored ribbon.
g To hide a 3D model with a magic hat
1. Select the 3D model.
2. Press the 3D model’s menu arrow, and then select Disguise > Disguised.
g To change the magic hat’s color
1. Select the magic hat.
2. Press the magic hat’s menu arrow, and then select Disguise > Change Color.
g To reveal a 3D model under a magic hat
Use Mixed Reality Tools as described in Manipulating 3D models using Mixed Reality Tools on page
60.
Stars swirl around the magic hat, and then the magic hat disappears after a few seconds, revealing
the 3D model behind it.
T  T I P
You can also reveal the 3D model by pressing the hat icon in the lower-left corner.
C H A P T E R 7
Using Mixed Reality Tools for the SMARTDocumentCamera
62