SMART 330 - Page 67

3. Place the mixed reality cube under the SMARTDocumentCamera, showing one side of the
cube to the camera.
SMARTNotebook software enters Mixed Reality mode and assigns the 3D model to the cube.
N  N O T E
SMARTNotebook software enters Mixed Reality mode in this situation only if a 3D model is
on the page. Alternatively, you can enter Mixed Reality mode by pressing SMART
Document Camera in the toolbar, and then pressing Mixed Reality Mode in the
SMARTDocumentCamera window.
4. Do any of the following:
o
To move the 3D model on the screen, move the cube.
o
To rotate the 3D model on the screen, rotate the cube in your hand.
o
To unassign the 3D model from the cube, cover the cube’s markings with your hand.
N  N O T E
If you experience any of the following symptoms, the cause may be issues with tracking:
o
The 3D model doesn’t connect to the cube.
o
The 3D model shakes when it’s connected to the cube.
o
The 3D model sporadically disconnects from the cube.
o
SMARTNotebook software enters Mixed Reality mode when the cube is under the
camera even if you aren’t moving the cube.
To address tracking issues, see Lighting requirements on page 50.
T  T I P S
o
As you move and rotate the cube in your hand, ensure you don’t cover the symbols on
the cube’s surface.
o
To hide the image from the SMARTDocumentCamera and show only the 3D model,
move the transparency slider to the left.
C H A P T E R 7
Using Mixed Reality Tools for the SMARTDocumentCamera
61