Remote Control
Smart MX 04 EN 13
Inserting Of Batteries
Figure 3: Inserting of batteries into the remote control
Open the battery compartment on back side of remote control. Insert two
batteries type AAA according to polarities mentioned on the battery
compartment. Push the cover of the battery com
partment carefully till the
cover is locked.
Replacing Of Batteries
Replace discharging batteries on time. Always replace both batteries
simultaneously and use batteries of the same type.
Safety Instructions
Attention!
Do not recharge or destruct normal batteries. Do not throw
them into fire.
Batteries may contain toxic agents that are hazardous to
health and environment. Therefore, dispose of the batteries
immediately according to the prevailing statutory regulations.
Never throw the batteries in normal household waste.
Note!
Always insert the batteries according to their polarities.
Batteries which are getting discharged may damage the
remote control. If you do not use the receiver for a longer
period of time, remove the batteries from the remote control.
To Next Page
Loading...
Need help?
General
