Operating At The Front Panel
Smart MX 04 EN 17
Operating At The Front Panel
Figure 6: Front side of the receiver
At the rear side of the receiver is the main supply switch. Here you should
switch the device off if it will not be used for longer time. Here you also have to
switch the device on afterwards.
With the On/Off switch at the front side you can switch your receiver to the
stand
by mode. If the receiver is in the standby mode, press the On/Off switch
to s
witch the receiver on.
On the display you can see the actual channel number.
For selecting the channels upwards press PR ▲, for
selecting the channels
downwards press PR ▼.
To Next Page
Loading...
Need help?
General
