SMART MX 04 - Motor Antenna Setup

Installation
Smart MX 04 EN 23
Motor Type
To change the activation of your satellite antenna, go to the menu Installation
on page 22.
Ö
Select the menu point Antenna Setup.
Ö To confirm press OK.
Ö
Select the menu point Motor Type.
Ö Select the kind of activation.
You can select between following settings:
• USALS
• DiSEqC 1.2
• For leaving the menu, press EXIT once or repeatedly.
Local Longitude
To change the local longitude, go to the menu Installation on page 22. This
menu point is only active when antenna setting is set on USALS (see chapter
Motor Type, page 23).
Ö
Select the menu point Antenna Setup.
Ö To confirm press OK.
Ö
Select the menu point Local Longitude.
Ö Select the direction (east / west) with VOL (+/-).
Ö
To confirm press OK.
Ö
Insert the longitude with the Numeric buttons (0~9).
Ö
For leaving the menu, press EXIT once or repeatedly.
Local Latitude
To change the local latitude, go to the menu Installation on page 22. This
menu point is only active when antenna setting is set on USALS (see chapter
Motor Type, page 23).
Ö
Select the menu point Antenna Setup.
Ö To confirm press OK.
Ö
Select the menu point Local Latitude.
Ö Select the direction (north / south) with VOL (+/-).
Ö
To confirm press OK.
Ö
Insert the latitude with the Numeric buttons (0~9).
Ö
For leaving the menu, press EXIT once or repeatedly.