SMART MX Series - Page 80

Appendix A
Adjusting iQ settings
smarttech.com/kb/171555 81
Option Values Function Notes User or system
setting
Default resolution
Auto
4K60
1080p60
720p60
640x480p60
Sets the HDMI out resolution. This option is not
available for
SMART Board
MX series
displays.
When changing
the output
resolution on
6000S (V3) and
MX (V3) models,
the HDMI output
may not be
visible for several
seconds.
System
HDMI Input
Advanced
HDMISettings
HDMI 1.0
HDMI 2.0
HDMI 3.0
OPS
VGA
Sets the HDMI version, HDP
pulse width, and MHL setup
delay for each HDMIinput.
You can also
enable or disable
strictly
conformant
HDMIInput
DDCSDA timing
and forbid or
allow HDCP2.2
with older
receivers.
This option is not
available for
SMART Board
MX series
displays.
System
Go to the Input Lobby
when there is no signal
On
Off
When enabled, show the input
previews when there is no
signal.
This option is not
available for
SMART Board
MX series
displays.
System
Audio
Audio In
These options are available for SMART Board 6000S (V3) models only.
l
Volume Range slider Sets the volume from the
microphone.
[N/A] System
l
Built-in microphone On
Off
Enables or disables the
display’s built-in microphone.
The default is on.
[N/A] System