HGMS62 Split Type Genset Controller User Manual Page 38 of 58
Indicate that ECU sends a shutdown alarm signal.
Action after not receiving speed signal during start idle-stop idle
when the engine type is ECU.
Action when the input port 1 is active.
Action when the input port 2 is active.
Action when the input port 3 is active.
Action when the input port 4 is active.
Action when the input port 5 is active.
Action when the input port 6 is active.
Action when the input port 7 is active.
Action when the input port 8 is active.
Action when the input port 9 is active.
Action when input port 1 shutdown alarm occurs.
Action when input port 2 shutdown alarm occurs.
Action when input port 3 shutdown alarm occurs.
Action when input port 4 shutdown alarm occurs.
Action when input port 5 shutdown alarm occurs.
Action when input port 6 shutdown alarm occurs.
Action when input port 7 shutdown alarm occurs.
Action when input port 8 shutdown alarm occurs.
Action when input port 9 shutdown alarm occurs.
Action when emergency stop alarm occurs.
Action when crank failure alarm occurs.
Action when stop failure alarm occurs.
Action when engine under speed warning occurs.
Action when engine under speed shutdown occurs.
Action when engine over speed warning occurs.
Action when engine over speed shutdown occurs.
Action when gen over frequency warning occurs.
Action when gen over frequency shutdown occurs.
Action when gen over voltage warning occurs.