Report, Post-Repair Report, and Diagnostic Scan (if no comparison is
required, users can select "Diagnostic Scan" type). The device has the
report comparison function, so it is necessary to select the correct report
type when saving the report. The service technician can clearly understand
whether the fault codes found before diagnosis have been completely
cleared after repairing through the comparison.
Enter the name of the inspector and customer, and then click OK to enter
the report detail view page.
On the report detail page, click Save to save the report. All saved test
reports can be viewed by clicking Reports in the main interface.
Click to select the pre-maintenance reports. By comparing the pre-
maintenance and post-maintenance diagnose reports, the service
technician can clearly understand whether the fault codes found before the
repair have been completely cleared after repairing.
Notes: Before executing the function, please make sure that the current
test vehicle's pre-repair diagnose report has been saved, and that it has
been repaired and cleared after the pre-repair diagnose report has been
saved, otherwise there will not be any difference between the pre-repair
report and the post-repair report.
Click to view the reason analysis of the fault code.
Click to clear all fault codes.
Notes: For general models, please strictly follow the regular order of
operation: first read the fault code, then clear the fault code, trial test, read
the fault code again for verification, service the vehicle, clear the fault
code, and trial test again to confirm that the fault code no longer appears.
4.2.2 System Scan
The function is used to scan what systems the vehicle is equipped with.
Click System Scan in the test option selection interface, the system starts to scan the vehicle
system. After the scanning is completed, the screen will display the scanning results.
To Next Page
Loading...