Users can manually select the vehicle electronic control system for test function operation. Click a
single electronic control system (e.g. "ECM") in the test item selection interface, and then click
"ENTER" to go to the test function selection page.
Note: Different models may have different test menus.
A. Module Information
The function is used to read the version information of the current ECU of the vehicle.
B. Read DTC
The function is used to read the current fault codes existing in the ECU of the vehicle, helping the
service personnel to quickly understand the causes of vehicle malfunctions.
Click Read DTC in the test item selection page, the screen will display the following detection
results.
To Next Page
Loading...