SMC Corporation LECP6 Series User Manual

- 18 -
Power supply plug
Insert into CN1
5. CN1: Power supply plug
5.1 Power supply plug specifications
The specifications of the provided power supply plug are as follows.
5.2 Electric wire specifications
Prepare electric wire according to the following specification:
Item Specifications
Applicable
wire size
AWG20 (0.5mm
2
): Single line, No insulation sleeve, Twisted wire with
bar terminal
* The rated temperature for the insulation coating: 60
o
C or more.
Stripped
section length
* Please insert only the peel line part when insert the electric wire in the power plug.
Caution
Multiple electric wires should not be connected to one terminal.
After the wiring of the power supply plug is completed, connect it to the CN1 connector of the controller.
Please refer to “5.3 Wiring of power supply plug (page 19)” for how to wire the power supply plug.
8mm
Controller
Power supply plug connected to CN1
Power supply plug
(*)
EMG
0V
M24V
C24VM
BK RLS
Terminal Function Descriptions
0V Common power (-)
The negative common power for M24V,
C24V, EMG and BK RLS.
M24V Motor power (+)
The positive power for the actuator motor to
be supplied via the controller.
C24V Control power (+) The positive control power.
EMG Stop signal(+)
The positive power for Stop signal.
(Motor is can operate to connect the 24V.)
BK RLS Lock release (+) The positive power for lock release.
(*)
Made by Phoenix Contact K.K. (Part no: FK-MC0.5/5-ST-2.5)
φ2.0 or less

SMC Corporation LECP6 Series Specifications

General

Brand	SMC Corporation
Model	LECP6 Series
Category	Controller
Language	English