SMC Networks PFCA7 Series - Analogue Input and Control Status Warnings; Output PD Range Warning

-71-
No.PF※※-OMA1002
Warning name
Warning display
Description
Measures
Control
operation in the
event of an error
Analogue input
warning
(Over signal)
(No signal)
Analogue input has exceeded
110%F.S. of the rated control
flow range.
Make sure that the
analogue input is
within the set flow
rate range.
Continuing
Analogue input is below
- 5%F.S. of the rated control
flow range.
Continuing
Waiting for the start of
local control operation
(Control start wait)
Stand-by state until the mode
shifts to measurement mode
after the power is turned on.
(When [Local] is selected in
the control selection setting
mode)
Start the operation
of the product after
the stand-by time
has elapsed.
Stop
Outside the output PD
range
(PD out of range)
The output PD of the
commanded flow rate is
beyond the range of 0 to 4120.
Make sure the
output PD of the
commanded flow
rate is within the
range of 0 to 4120.
Value before the
event
2023-12-20 14:49
DL145266