SMC Networks PFCA7 Series User Manual

-70-
No.PF※※-OMA1002
■Warning/Error display
This function is to display error location and content when a problem or error has occurred.
: If the error cannot be reset after the following measures are taken, or errors other than the following are displayed, please contact
SMC for further investigation.
○Warning display
Warning name
Warning display
Description
Measures
Control
operation in the
event of an error
Above the
instantaneous flow
measurement
(HHH)
A flow rate exceeding the
upper limit of the displayable
range is applied.
Check that the flow
is within the product
specification.
Continuing
Below the
instantaneous flow
measurement
(LLL)
A flow rate below the lower
limit of the displayable range
is applied.
Mount the product
so that the fluid flow
direction is the
same as the arrow
indicated on the
side of the body.
Continuing
Above the
accumulated flow
measurement
(Reached accum max)
(Reached accum low)
The accumulated value
exceeded the accumulated
flow range.
(For accumulated increment)
Reset the
accumulated flow.
(Press and hold the
SET and DOWN
buttons
simultaneously for
1 second or longer.)
Continuing
The accumulated value has
reached the set accumulated
value.
(For accumulated decrement)
Continuing
Automatic
accumulation shut-off
(Automatic shutoff)
The control operation has
stopped because the
accumulated value reached
the set value.
(When automatic accumulation
shut-off is enable)
Reset the
accumulated flow.
(Press and hold the
SET and DOWN
buttons
simultaneously for
1 second or longer.)
Stopped
2023-12-20 14:49
DL145266

SMC Networks PFCA7 Series Specifications

General

Brand	SMC Networks
Model	PFCA7 Series
Category	Controller
Language	English