-9-
No.PF※※-OMA1002
Operating environment
•Do not use in an atmosphere containing corrosive gases, chemicals, sea water, water, water steam, or
where there is direct contact with any of these.
These may cause failure or malfunction.
•Do not use the product in a place where the product could be splashed by oil or chemicals.
If the product is to be used in an environment containing oils or chemicals such as coolant or cleaning solvent, even
for a short time, it may be adversely affected (damage, malfunction, or hardening of the lead wires).
•Do not use in an area where electrical surges are generated.
When there are machines or equipment that generate large surges near the product (magnetic type lifter, high
frequency inductive furnace, motor, etc.), this can result in deterioration and damage of the internal circuit elements.
Take protective measures to isolate the surge sources and prevent the lines from coming into close contact.
•Do not use a load which generates a surge voltage.
When a surge voltage-generating load such as a relay or solenoid valve is directly driven, use the product with a
surge absorbing element built-in.
•The product is CE/UKCA marked but is not immune to lightning strikes. Take measures against lightning
strikes in the system.
•Mount the product in a location that is not affected by vibration or impact.
Otherwise, a failure or malfunction may be caused.
•Do not use the product in the presence of a magnetic field.
Otherwise, a malfunction of the product may be caused.
•Do not let foreign matter, such as wire debris, get inside the product.
Otherwise, a failure or malfunction may be caused.
•Do not use the product in an environment that is exposed to temperature cycles.
Temperature cycles other than ordinary changes in temperature can adversely affect the internal components of the
product.
•Do not expose the product to direct sunlight.
If using in a location directly exposed to sunlight, shade the product from the sunlight.
Otherwise, a malfunction may be caused.
•Keep within the specified temperature range.
Operation under low temperature may lead to damage or operation failure due to frozen moisture in the air.
Protection against freezing is necessary.
The installation of an air dryer is recommended for elimination of drainage and water.
Avoid abrupt temperature changes even within the specified temperature range.
•Do not operate close to a heat source, or in a location exposed to radiant heat.
Otherwise malfunction can result.
•Do not install the products close to each other or do not close the vent hole when installing the product.
Otherwise, the temperature of the product may rise, resulting in a failure or malfunction.
To Next Page
Loading...
Need help?
General
