SMC Networks ProtoCessor FPC-ED2 - Change the Protocessor IP Address; Figure 16: Ethernet Port Network Settings

Configuring the Gateway
VorTek ProtoCessor Start-up Guide 17
6.2 Change the ProtoCessor IP Address
• Enable DHCP to automatically assign IP Settings or modify the IP Settings manually as needed,
via these fields: IP Address, Netmask, Gateway, and Domain Name Server1/2.
NOTE: If the FieldServer is connected to a router, the IP Gateway of the FieldServer should be set
to the same IP Address of the router.
• Click the Save button to activate the new settings.
NOTE: If the webpage was open in a browser, the browser will need to be pointed to the new IP
Address of the ProtoCessor before the webpage will be accessible again.
NOTE: For Router settings go to Section 10.9.
Figure 16: Ethernet Port Network Settings