40
【Modify Shift Content】: select the shift from the list on the left, then edit its content on the right side, 【Add】
will change to【Modify】,click【Modify】to save
【shift name】: Maximum 30 characters, can be Chinese, English letters, numbers or symbols (no special
symbols).
【Save shift】: Click to save.
Edit: Selected the shift from the 【shift list】, click “edit” popup the editing interface, click “save” to
save the changes. The default shift cannot be edited.
Select All: All shifts in the list was chosen; Click the switch again change to all don't choose, all not
to choose.
Delete: Select the newly shifts can be deleted. The default shift cannot be deleted
Closing Shift Management: Click on close, out of management interface and save existing shifts.
【Character】:
Font: Select the font.
Size: Set the font size.
Font effect: Bold, Italic, Add under horizontal line, Add font with horizontal
line
Cut Edge: Set whether the objet with white lace.
【Location】
X axis coordinates: Input range -10-3000mm, you can click buttons to adjust slightly.
Y axis coordinates: Input range according to canvas amount limited, also can click buttons to
adjust slightly.
Width: You can enter 10% to 300%, the greater value, the larger width font.
Height: You can enter 10% to 300%, the greater value, the higher font.
Lock scale: The proportion of font height and width. After select this function, when modify the font width or
height, the font will be proportionally adjusted. Tips: If the data location beyond the canvas, it will turn yellow,
after saving only the content within the canvas can be printed.
【Rotation】
Rotation: Input range 0-359, also can click buttons to adjust.
To Next Page
Loading...
