Solcon RVS-DN 8 - Page 67

67 • Control Keypad
________________________________________________________________________________________________
Appears only in
MAXIMIZED MODE
(1)
Appears only in
MAXIMIZED MODE
(1)
Appears only in
MAXIMIZED MODE
(1)
Appears only in
MAXIMIZED MODE
(1)
EN. SAVE & SL. SPD
PARAMETERS
FAULT PARAMETERS
- **** -
I/O PROGRAMMING
PARAMETERS
COMM.PARAMETERS
- **** -
STATISTICAL DATA
- **** -
Display and default
values
Display and default
values
Display and default values Display and default
values
Display and default
values
SAVING ADJUST.
0 (MIN)
PHASE LOSS Y/N
YES
PROG. INPUT #7
RESET
PROTOCOL
MODBUS
LAST STRT PERIOD
NO DATA
SLOW SPEED TORQ.
8
PHASE SEQ. Y/N
NO
PROG. INPUT #8
DUAL ADJUSTMENT
BAUD RATE
9600 (MODBUS)
LAST STRT MAX I
NO DATA
MAX SLOW SP TIME
30 SEC.
INSULATION ALARM
OFF
FAULT RELAY TYPE
FAULT
PARITY CHECK
EVEN
TOTAL RUN TIME
0 HOURS
STORE ENABLE
SPECIAL FEATURES
INSULATION TRIP
OFF
IMM/ S.PIN RELAY
IMMEDIATE
SERIAL LINK NO.
OFF
TOTAL # OF START
0
AUTO RESET
NO
RELAY ON DELAY
0 SEC.
S. LINK PAR. SAVE
DISABLE
LAST TRIP
NO DATA
THERMISTOR TYPE
PTC
RELAY OFF DELAY
0 SEC.
SER. LINK CONTROL
DISABLE
TRIP CURRENT
0 % OF FLA
THERMISTOR TRIP
OFF
AN. OUT PARAMETER
I, 0...200% OF FLA
MODBUS TIME OUT
OFF
TOTAL # OF TRIPS
0
UNDER CUR. RESET
OFF
STORE ENABLE
I/O PROG.PARAMETERS
FRONT COM ADDRES
OFF
PREVIOUS TRIP -2
NO DATA
STORE ENABLE
FAULT PARAMETERS
STORE ENABLE
COMM. PARAMETERS
Applicable when
Optional Modbus
PCB installed
.
.
.
Applicable when
Optional Profibus
PCB installed
PREVIOUS TRIP -9
NO DATA
COMM. PROTOCOL
PROFIBUS
Appears when in
TEST/MAINTENANCE
(2)
BAUD RATE
AUTO (PROFIBUS)
TEST/MAINTENANCE
***OPTIONS***
Display and default
values
PROFI.NETWORK ID
126
RUN SELF TEST?
PUSH UP ARROW
S. LINK PAR. SAVE
DISABLE
BTL-19/03/2006
STRT.DN-020407
SER. LINK CONTROL
DISABLE
STORE ENABLE
DEFAULT PARAMETERS
MODBUS TIME OUT
OFF
RESET STATISTICS
FRONT COM ADDRES
OFF
VOLTAGE ADJUST
X VOLT
STORE ENABLE
COMM. PARAMETERS
CURRENT ADJUST
X% OF FLC
(1)
- Refer to section 6.5.1 on page 56 for changing mode from MINIMIZED MODE to MAXIMIZED MODE.
(2)
- Refer to section 7.5 on page 62 for entering TEST/MAINTENANCE.