times as required to allow the mix to be built up fader by fader. Each time a rollback takes place, the rollback
counter in the mix status display increments. Faders in write at a rollback point will automatically switch to write
when the system plays through the rollback point.
Join and Revise
At any time during Mix Review, the Join key can be used to switch all channels originally in write at the last
rollback point back to write at the levels or state they were at the rollback point. This is useful, for example, when
balancing a chorus level. When you have achieved this balance, you can rollback, hit Join and the levels will punch
in at the balance set before rollback, and all channels immediately return to write.The Revise key has a similar
action except that all channels in write at the Rollback point are returned to write at their current mix position. This
is useful if you have been automating a section, but made a small mistake. Just rollback prior to the mistake, hit
Revise and the channels will immediately go into write at the current fader level, allowing you to overwrite the
mistake.
Multiple Rollback memories are supported so that successive operations of Join or Revise return different sets
of faders back to the write state, if multiple Rollback operations have taken place.
To return all faders to Absolute, operate the Join or Revise keys until the Global Rollback memory is reached, at
which point all faders return to write either at the current position, via the Revise function, or at the balance at the
Global Rollback point, via the Join function.
Discard
If the system is in play or stopped following a Rollback operation with any faders or cuts in Absolute mode, Discard
clears any data made since the start of the Rollback pass and forces all channels in Absolute back to Replay. The
Discard label is only shown when there is Mix data to discard.
JO IN
ROLLBACK
Point 2
ROLLBACK
Point 1
Global
Rollback
Point
Pass 4
Pass 3 (Channels 7-8 in
Absolute)
Pass 2 (Channels 1-6 in
Absolute)
Mix Review M ix Running
Time
Pass 1 (A ll Channels in
Absolute)
Start Rollback pointPress Join Key
Will jum p to rollback point level
Original A u to m a tion
New Autom ation
JO IN FU N C T IO N
Start Rollback pointPress Join Key
Will jum p to rollback point level
and start w riting new data
JO IN FU N C T IO N
Start Rollback point
Will start w riting new data
fro m cu rre n t level
REVISE FUNCTION
Press Join Key
Start Press the Join Key Rollback Point Start Press the Revise Key Rollback Point
JOIN FUNCTION
Will jump to rollback level when
Join is pressed and write new
data
REVISE FUNCTION
Will stay at current mix level when
Revise is pressed and write new
data
Original Automation
New Automation