Mix Running
Press Play on the DAW to move forward and as soon as the Mix system has locked to the MIDI timecode (MTC),
the Mix Status display will indicate ‘Mix Running’. Simply move the faders and press the cut switches to write
your mix automation, and the fader moves and cut data will be recorded. The DAW may be toggled freely between
Stop and Play and if Fast Forward is used or the DAW is located forward, the automation data will be extended
to the new position and returned to play.
At any time you can rewind the system, and as soon as the DAW is located to an earlier time and valid MTC or
a MMC locate position command is received, the mix system enters ‘Mix Review’. All faders will switch to Replay
status (all LEDs are off). This operation is known as a rollback.
When the DAW returns to Play, previously written automation data is replayed. If no faders are returned to write,
all faders in write at the start of the mix will drop back into write at the point where the DAW was rewound (the
‘rollback point’, and the Mix status will return to Mix Running. Whilst in Mix Review you may rollback as many
AWS 900+ Owner’s Manual
7-5
AWSomation
24 Channel
Faders
Stereo Bus
Master Faders
Press End to
save the
current Mix
Pass and
return to the
List Mix menu.
Revise returns faders
and cuts that were in
write when you rolled
back to write at the
current mix level.
Join returns faders and
cuts that were in write
when you rolled back to
write at their levels at the
rollback point.
Press Discard to
abort the current
Mix Pass
Indicates how many times you have rolled
back. Every time the Mix Review number
will increase by 1.
Mix Running Status - displayed while writing
new automation data
Mix Review Status - displayed when rolled back
and playing previous automation data.
To Next Page
Loading...
Need help?
General
