OPERATING MANUAL PAT-1, PAT-2, PAT-2E, PAT-10 version 1.02
Press ENTER to enter the update mode. The
update process is described in section 8.
After changing the parameters, you may exit SETUP menu:
Press and hold ENTER button for approx. 2 s
to memorize settings (not applicable for Up-
date screen)
or use ESC button (2s) to go to the meas-
urement screen without confirming the
changes.
Note:
The test parameters’ settings (times, limits, others) presented in this manual
are exemplary, and may differ from the ones pre-set in the tester.
Some tests require mains power supply, and will not run until the tester is connected to mains (plug
symbol is flashing). Connect the tester to mains power supply to run the test.
During the measurement the tested appliance must be switched on.
4.1 Introduction
Beyond all doubt, safe use of machinery and equipment is the responsibility of the owner (company
owner, home user), therefore, to state that the equipment is safe, regular checks and tests should be
performed, based on the approved standards, appliances' user manuals.Tested appliances labelled
as out of order, or the ones with expired check-up dates, should be immediately withdrawn from use.
It is forbidden to use damaged or faulty work tools and safety equipment.
Note that not only power tools should be tested. Extension cords, office and kitchen equipment or
production machines are equally prone to damage. These items are frequently exposed to damage,
To Next Page
Loading...
