SN8P2624
8-Bit Micro-Controller
SONiX TECHNOLOGY CO., LTD Page 35 Version 0.3
2.3.2 STACK REGISTERS
The stack pointer (STKP) is a 3-bit register to store the address used to access the stack buffer, 11-bit data memory
(STKnH and STKnL) set aside for temporary storage of stack addresses.
The two stack operations are writing to the top of the stack (push) and reading from the top of stack (pop). Push
operation decrements the STKP and the pop operation increments each time. That makes the STKP always point to
the top address of stack buffer and write the last program counter value (PC) into the stack buffer.
The program counter (PC) value is stored in the stack buffer before a CALL instruction executed or during interrupt
service routine. Stack operation is a LIFO type (Last in and first out). The stack pointer (STKP) and stack buffer
(STKnH and STKnL) are located in the system register area bank 0.
0DFH Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
STKP
GIE - - - - STKPB2 STKPB1 STKPB0
Read/Write R/W - - - - R/W R/W R/W
After reset 0 - - - - 1 1 1
Bit[2:0] STKPBn: Stack pointer (n = 0 ~ 2)
Bit 7 GIE: Global interrupt control bit.
0 = Disable.
1 = Enable. Please refer to the interrupt chapter.
¾ Example: Stack pointer (STKP) reset, we strongly recommended to clear the stack pointer in the
beginning of the program.
MOV A, #00000111B
B0MOV STKP, A
0F0H~0FFH Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
STKnH
- - - - - SnPC10 SnPC9 SnPC8
Read/Write - - - - - R/W R/W R/W
After reset - - - - - 0 0 0
0F0H~0FFH Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
STKnL
SnPC7 SnPC6 SnPC5 SnPC4 SnPC3 SnPC2 SnPC1 SnPC0
Read/Write R/W R/W R/W R/W R/W R/W R/W R/W
After reset 0 0 0 0 0 0 0 0
STKn = STKnH , STKnL (n = 7 ~ 0)
To Next Page
Loading...
