Sony Ericsson M600i - Sending and receiving files; Infrared port; USB Port

58 Connecting to Other Devices M600i
This is the Internet version of the user guide. © Print only for private use.
Sending and receiving files
You can use Bluetooth to send a file from any
application with a
Send as option, without
having to pair with the receiving device. To
send a file, select
Send as > Bluetooth in the
More menu and your phone will search for
available devices. Select one of them.
If another Bluetooth device sends an item to
your phone, a dialog may appear (mobile
network operator-dependent) with options for
accepting or rejecting the file transfer. When
the transfer is complete you will find the file in
the Messaging application in the
Messages
inbox. If the device is paired with your phone,
you can mark
Trust this device to allow it to
connect to your phone again in the future
without confirmation.
Infrared port
When you connect your phone to another
device using an infrared link, the infrared ports
of both devices must be within 3.3 feet (1
meter) of each other, in line of sight, and at an
angle of no more than about 30 degrees.
See Infrared Port on page 71 for information
on how to activate the infrared port.
WARNING! Never point an active infrared
port at your or someone else's eyes or the port
of infrared devices other than the one you are
connecting to.
Sending and receiving files
You can use the infrared port to send a file
from any application with a
Send as option.
To send a file, select
Send as > IR in the More
menu.
When the transfer of a file sent to your phone
is complete you will find the file in the
Messaging application in the
Messages inbox.
USB Port
You can use a USB (Universal Serial Bus)
cable to connect your phone to the USB port of
another device.
See USB on page 72 for more information on
how to adjust USB settings.
Note: Before connecting the USB cable to a
computer, install the Sony Ericsson PC Suite
on the computer.
You must connect your phone to a computer
using a USB connection, with the
Phone
mode
setting, to perform phone data backups
or restore data from a backup.
A USB connection, with the File transfer
setting, is also required to use the Sony
Disc2Phone™ and Adobe® Photoshop®