M600i Control Panel 73
This is the Internet version of the user guide. © Print only for private use.
dimmed level you set on the Brightness
tab.
Brightness tab
Select the backlight mode and adjust the
brightness with the slider or Jog Dial.
Select Default to reset all light levels to the
factory defaults.
Device Management
Device management enables the remote
distribution of settings for your phone (for
example, Internet, email, SMS, and MMS
settings). It also makes it possible to manage
(list, install, update, and uninstall) themes and
client software on a group of phones. As an
example, device management is useful when
an enterprise has defined a set of standard
software that all employees’ phones should
contain.
To enter settings into or manage software in
your phone, a device management session is
set up between it and a device management
server. A session can be initiated by you or the
server.
Device management dialog
Select Tools > Control panel > Device >
Device management
. The device
management server profiles, if any, are listed.
The settings for the profile describe how it will
respond to the start of a Device management
session and the notifications communicated
during the session. In the Device management
dialog, you can:
• Initiate the phone management session by
highlighting a profile, then selecting
Connect.
• Create a new device management server
profile manually by selecting
More > New
profile
.
• Initiate reconfiguration for a new mobile
network operator by selecting
More >
Clear ACL
. This might be necessary if
your phone is already configured for
another mobile network operator.
• Edit or delete device management server
profiles.
Note: A profile may be locked by the mobile
network operator. If this is the case, you
cannot edit or delete the profile or clear ACL.
The device management dialog consists of two
tabs,
Details and Settings. In the Details tab,
you can edit connection details, such as the
username for the device management server
account and the server ID and address. In the
Settings tab, you set the behavior of the device
management session.
To Next Page
Loading...
