66
US
4 Press
1'/~
to
select the desired setting.
• "AUTO": Normally select this. The
system changes "RF CHANGE"
to
"ON"
or "OFF" automatically.
• "ON": The system transmits sound by
searching for a better channel for
transmitting.
• "OFF": The system transmits sound by
fixing the channel for transmitting.
5 Press
8.
The setting is made.
6 Press SYSTEM MENU.
The system menu turns off.
7 When you set "RF CHANGE"
to
"OFF,"
select the
10
so that sound
transmission is
most
stable (page 61).
..
•
In
most cases, you will not need to change this
setting.
-
If
"RF
CHANGE"
is
set to "OFF," transmission
between the unit and S-AIR sub unit can be
performed using one
of
the following channels.
- S-AIR ID
A:
equivalent channel for IEEE
802.11
bIg channel I
- S-AIR ID
B:
equivalent channel for IEEE
802.11
bIg channel 6
- S-AIR ID
C:
equivalent channel for IEEE
802.11
bIg channel
II
• The transmission may be improved by changing the
transmission channel (frequency)
of
the other
wireless system(s). For details, refer to the operating
instructions
of
the other wireless system(s).
To Next Page
Loading...
