For
the
surround
amplifier
For
the
S-AIR
receiver
-
Press
"'/~
repeatedly
until
lOS-AIR
MENU" appears
in
the
front
panel
display,
then
press
0
or~.
Press
't/~
repeatedly
until
"RF
CHANGE" appears
in
the
front
panel
display,
then
press
0
or~
.
Press
't/~
repeatedly
until
lOS-AIR
MENU" appears
in
the
front
panel
display,
then
press
0
or~.
Press
't/~
repeatedly
until
lOS-AIR
INFO" appears
in
the
front
panel
display,
then
press
0
or~.
The S-AIR ID
of
the unit appears in the
front panel display. When the unit is paired,
"(PAIRING)" appears beside ID.
Press SYSTEM MENU.
The system menu turns off.
3
If
you use multiple wireless systems which share
the 2.4 GHz band, such as wireless LAN or
Bluetooth, the transmission
of
S-AIR products
or other wireless systems may be unstable. In
this case, the transmission may be improved by
changing the following
"RF
CHANGE" setting.
1 Press SYSTEM MENU.
2
4
3
You can check the S-AIR status such as the
S-AIR ID or pairing information.
1 Press SYSTEM MENU.
2
mJ
•
To
press PAIRING on the rear panel
of
the
surround amplifier, a slim instrument, such
as
a
paper clip, can be used.
•
For
the
S-AIR receiver
Refer to the operating instructions
of
the
S-AIR receiver.
When sound transmission is established,
"PAIRING" and "COMPLETE" appear
alternately in the front panel display.
-
• Perform pairing within several minutes
of
Step
5.
If
you do not, "PAIRING" and
"INCOMPLETE" appear alternately
in
the front
panel display.
To
continue pairing, press 0 and
start again from Step
5.
To
cancel pairing, press
SYSTEM MENU.
S Press SYSTEM MENU.
The system menu turns off.
-
• When you perform pairing, "(PAIRING)" appears
beside ID on the display for selecting ID.
6 Press
't/~
repeatedly
until
"START"
appears
in
the
front
panel display,
then
press
O.
The unit starts pairing and "SEARCH"
flashes in the front panel display.
To cancel pairing, press SYSTEM MENU.
7
Start
pairing
of
the
S-AIR
sub
unit.
•
For
the
surround
amplifier
Press POWER on the surround amplifier
to
tum on the surround amplifier and press
PAIRING on the rear panel
of
the surround
amplifier.
The PAIRING indicator
of
the surround
amplifier flashes red when pairing starts.
When sound transmission is established,
the PAIRING indicator
of
the surround
amplifier turns red and "PAIRING" and
"COMPLETE" appear alternately in the
front panel display.
To
cancel
pairing
Change the ID setting
of
the unit by using the
S-AIR ID switch
of
the unit.
If
you select a new
ID, pairing is canceled.
65
US
To Next Page
Loading...
