Sony DCR-PC110 - Page 63

Dubbing only desired scenes - Digital program editing
When you connect using i.LINK cable (DV connecting cable) (not supplied), follow the
procedures below.
(1) Set the POWER switch to VCR on your camcorder.
(2) Turn the power of the connected VCR on, then set the input selector to DV
input.
When you connect a digital video camera recorder, set its power switch to
VCR/VTR.
(3) Press MENU to display the menu.
(4) Turn the SEL/PUSH EXEC dial to select _, then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.
(6) Turn the SEL/PUSH EXEC dial to select CONTROL, then press the dial.
(7) Turn the SEL/PUSH EXEC dial to select i.LINK, then press the dial.
5'
3
MENU
OTRERS
__MELODY
COMMANDER
_ DISPLAY
_:l VIDEO ED{T
ED_TSET
_,%T
__ I R
'CUT I_ ¸¸
'OUT OUT ¸¸
_z_ IR SETUP
,_ P_USEMODE
[_]_ IR TEST
• _ _RETURN
6,7 ©
r_
I c
_ LINK
ADJ TEST
CUT IN
r_ _ CUT OUT'
IR SETUP
P_USEMOD
_w ]R TEST
_RETURN
[MENU] END
63