100
Basic Switcher Settings
Chapter 3 Preparations
The settings made here are applied to all child windows of the same size. It
is not possible to specify display positions for individual child windows.
Title display positions and parameter values
3
After editing the file parameters, save the file back to the USB flash drive
(overwriting the old file), and then insert the flash drive into the USB
MEMORY connector again.
4
Carry out steps 2 to 4 of the procedure in “Changing signal display names”
to display the Signal sub menu, and then hold the F4 knob down for one
second or longer.
The updated file is loaded into the switcher.
The above operations alone do not cause child window titles to be
displayed. Continue by carrying out step 5 below.
5
Carry out steps 1 to 3 of the procedure in “To specify the partition type and
assign output video to child windows” (page 97) to display the MV1 or
MV2 sub menu, and then carry out step 8 to turn the display of child
window titles on.
LargeHeight Specifies the height of characters in
large child windows.
0 to 50
SmallOffsetV Specifies the vertical display position in
small child windows.
0 to 25
SmallOffsetH Specifies the horizontal display
position in small child windows.
0 to 25
SmallWidth Specifies the display width in small
child windows.
0 to 25
SmallHeight Specifies the height in characters in
small child windows.
0 to 25
HalfMatte Specifies whether to add a background
(half matte black rectangle) behind
signal name displays.
ON: Add background
OFF: Do not add
background
Parameter Description Setting values
Note
Note
Large
(Small)
OffsetH
(horizontal
position)
Large (Small)
Width (display width)
Large (Small)
OffsetV (vertical position)
Large
(Small)
Height
(character
height)
Title display
To Next Page
Loading...
