Sony DFS-900M - Playing Sequences

158
Sequence Operations
Chapter 6 Registering Operations and Settings
1 Press the SEQ button in the numeric keypad.
The numeric keypad enters sequence mode.
The most recently used sub menu appears in the
display panel.
2 Press the j and J buttons in the numeric keypad
until the Seq Setup sub menu appears.
3 Rotate the F2, F3, and F4 knobs to select whether to
change M/E, keyer, and DSK settings when the
sequence is played.
When using the BKDF-901
When using the BKDF-902
When a sequence is recalled, the settings of the
recalled sequence are reflected, but they are reflected
to the currently displayed video instead of to the video
that was selected at the time when the sequence was
registered.
Playing Sequences
You can use the following four buttons in the numeric
keypad to play a sequence after recalling it.
Knob Parameter Description Settings
F2 BUS M/E settings
other than
keyer settings
On: Do not
change the
current
settings.
Off: Replace the
current
settings with
the sequence
settings.
F3 Keyer Keyer
settings
F4 DSK Downstream
key settings
BKDF-901
BKDF-902
Knob Parameter Description Settings
F2 BUS M/E settings
other than
keyer
settings, and
PROGRAM/
PRESET
settings
BUS Off:
Replace M/E,
and
PROGRAM/
PRESET
settings with
the sequence
settings.
BUS On: Do not
change M/E,
and
PROGRAM/
PRESET
settings.
ME On: Do not
change the
current M/E
settings.
Replace
PROGRAM/
PRESET
settings with
the sequence
settings.
PP On: Do not
change the
current
PROGRAM/
PRESET
settings.
Replace M/E
settings with
the sequence
settings.
F3 M/E Keyer
settings
On: Do not
change the
current
settings.
Off: Replace the
current
settings with
the sequence
settings.
F4 DSK DSK settings