106
Basic Switcher Settings
Chapter 3 Preparations
Setting the Date and Time
Use the following procedure to set the date and time of the switcher’s internal
clock.
1
When using the BKDF-901: If the SHIFT button of the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step 2.
2
Press the SYSTEM button.
A settings sub menu of the System sub menu appears in the display panel.
3
Press the h or H button in the numeric keypad until the Date Adj. (set
date) sub menu appears.
“Date Adj.” appears in the sub menu title display area. If it is already
displayed there, you can skip this step.
4
Rotate the F2, F3, and F4 knobs to set the year, month, and day.
The correspondence between knobs and parameters is as follows.
5
Hold the F1 knob down for one second or longer.
The date is set.
BKDF-901
BKDF-902
Knob Parameter Description Setting range
F2 Y Year 2000 to 2100
F3 M Month 1 to 12
F4 D Day 1 to 31
To Next Page
Loading...
