121
Using Internally Stored Still Images
Chapter 4 Basic Operations
32-bit files cannot be stored in memory locations other
than STL1 to STL4.
Writing Still Images to USB Flash
Drives
1
Connect the USB flash drive to which you want to
store an image file to the USB MEMORY connector.
2
When using the BKDF-901: If the SHIFT button in
the DME/SETUP block is not lit, press it to light it.
When using the BKDF-902: Skip to step 3.
3
Press the STILL button.
The Still Store menu appears in the display panel.
4
Use the h and H buttons in the numeric keypad to
switch to the Export Still sub menu.
5
Set the parameters.
a) “Overwrite” appears in the F3 knob operation area if a file with the
same number already exists on the USB flash drive, and “New File”
appears if no file with the same number exists.
6
Press the F4 knob and hold it down for one second or
longer.
Export to the USB flash drive starts.
During the download, the STILL button lights in red.
When the download finishes, the button returns to lit in
orange.
The exported file is stored in the Stl folder of the USB flash
drive. If the Stl folder does not exist, it is created
automatically.
Deleting Still Image Files
Note
BKDF-901
BKDF-902
Knob Parameter Description Settings
F1 Fmt File format BMP, TGA
F2 File File number
00 to 99
a)
Tip
BKDF-901
BKDF-902
To Next Page
Loading...
