Sony DFS-900M - Adding Lighting Effects

146
Customizing DME Effects
Chapter 5 Adjusting Wipes and Keys
Defocus effect example
Adding Lighting Effects
You can adjust the parameters of the Light sub menu to
add lighting effects to images.
Example of a lighting effect applied to a ripple effect
Use the sub menus of the Light sub menu to do the
following.
a) xxx: “M/E DME” appears if you are setting up a transition, and “Keyer”
appears if you are setting up a key.
b) Shown only in GUI menu screens
To display the Light sub menus
When using the BKDF-901: Press the SHIFT button in
the DME/SETUP block, lighting it, and then press the
LIGHT button.
When using the BKDF-902: Press the LIGHT button in
the DME/SETUP block.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the h and H
buttons in the numeric keypad.
To select the type of light source in the
Type sub menu
Light 1 and Light 2 sub menu parameters
When you have selected 1-HL or 2-HL in the Type sub
menu, use the Light 1 and Light 2 sub menus to adjust the
size and position of the light source and to adjust the color
of highlighted parts.
The Light 1 and Light 2 sub menus each have two pages.
To switch between pages, press the h and H buttons in
the numeric keypad.
(xxx: “M/E DME” appears if you are setting up a
transition, and “Keyer” appears if you are setting up a key.)
xxx L1/xxx L2 Position (Position)
Lxxx L1/xxx L2 Color (Color)
Operation Knob Parameter Settings
Adjust the
amount of
blurring.
F4 Amt
(Amount)
0 to 100
Sub menu Operation
xxx DME L.Type
a)
(Type)
Select the type of light source.
Light 1 and 2
b)
Specify the size of the light source,
its position, and the color of
highlighted parts.
Operation Knob Parameter Settings
Select the
type of light
source.
(Select Off if
you do not
want to add a
lighting effect
to the image.)
F1 Typ (Type) Off: No light
source
1-HL: Highlight 1
2-HL: Highlight 1
HL/LL: Highlight
and low-light
Operation Knob Parameter Settings
Specify the size
of the light
source (plane
light source)
F1 Siz (Size) 0.0 to 100.0
Specify the X
coordinate of
the center point
of the light
source.
F2 PX (Position
X)
–1.000 to 1.000
Specify the Y
coordinate of
the center point
of the light
source.
F3 PY (Position
Y)
–1.000 to 1.000
Specify the Z
coordinate of
the center point
of the light
source.
F4 PZ (Position
Z)
–1.000 to 1.000
Operation Knob Parameter Settings
Specify the
mixing ratio
between the
color of the
highlighted
parts and the
base color.
F1 Opac
(Opacity)
0 to 100.0